Enter your email to subscribe to our newsletter
Keep up to date with our latest products, offers and news.
Submit
POLYGRAB polystyrene contact adhesive
image
image   image   image   image
  Tac-Fast
  Grabfast H2O  
 
   
image   image   image
image

POLYGRAB polystyrene contact adhesive

FEATURES

Speed of application
Self contained low maintenance system
Low odour
Fast drying time
Even coverage
Moisture resistant
Long lasting high tack adhesion

TECHNICAL DATA

Coverage approximately 500 sq meters
Higher coverage achieved on perfect or
metal access floors
Appearance clear liquid
Zero VOCS
Non flammable
Solvent free
Water based

SURFACE PREPERATION

All surfaces must be clean, dry and free from oil, grease and paint. Any excessive dust must be removed as failure to do so will impair the performance of the adhesion. If applying the adhesive directly on to concrete, or sand and cement screeds, they must be fully cured and laitance free. If applying to earth subfloors an efficient damp proof membrane must be incorporated. Site conditions must comply with British Standards CP 102 (Code of practice for protection of building against water from underground), BS 5325 (Installation of textile floor coverings) and all supplementary publications must be followed throughout the installation.

  POLYGRAB polystyrene contact adhesive

TAC-FAST is a fast drying, high tack carpet tile adhesive. It is designed for bonding carpet tiles to a wide range of substrates including wood, metal and concrete. The bulk aerosol system has no wastage and has proved to be seven times fast than the traditional trowelling of adhesives.

To apply the adhesive simply position the wand approximately 40-50cm from the floor and spray the adhesive evenly in a thin layer moving constantly across the area to be coated. In order to achieve a releasable bond allow the adhesive to dry, it will adopt a clear appearance as it does so, depending on the thickness of coverage and the room atmosphere this will take approximately 10 minutes. Once the carpet tiles have been laid they can be repeatedly lifted without damaging the adhesive or substrates, however if the tiles are laid whilst the adhesive is still wet a permanent bond will be formed.

If the system is to stand unused for a while then it is advisable to flush it out with Gemini Adhesives GUNWASH so it is ready for instant use in the future.

It is the users responsibility to ensure that the adhesive is suitable for the substrates to be bonded, if you are unsure

image
TAC-FAST technical data sheet
PDF
image
TAC-FAST
Material safety data sheet

PDF


 
image        
image
Gemini Logo Gemini Adhesives Limited, New Building, Top Road, Osgathorpe, Leicestershire, LE12 9TB
Freephone: 0800 3284267 | Tel: 01530 224712 | Fax: 01530 223514 | Email: info@geminiadhesives.com